ESP PCB/E Series
The ESP PCB/E Series is a combined Category D, C, B tested protector (to BS EN 61643) for ‘through hole’ mounting directly onto the PCB of data communication, signal or telephone equipment which require a lower in-line resistance, an increased current or a higher bandwidth than the PCB/**D Series.
Available for working voltages of up to 110 Volts for AC & DC power applications up to 1.25 Amps. For use at boundaries up to LPZ 0 to protect against flashover (typically the service entrance location) through to LPZ 3 to protect sensitive electronic equipment.
Features & benefits
-
Suitable for wave soldering
-
Very low let-through voltage (enhanced protection to IEC/BS EN 62305) between all lines
-
Full Mode design capable of handling partial lightning currents as well as allowing continual operation of protected equipment
-
Repeated protection in lightning intense environments
-
Very low (1 Ω) in-line resistance for resistance critical applications
-
High (1.25 A) maximum running current
-
Higher bandwidth enables higher frequency data communications
-
2 pin clean end and 3 pin line end to ensure correct insertion